kothint
|
My Honda hybrid 2009 can’t start after engine stop. 3,4 hour wait and can start. I go to good work shop. work shop master do not know because my car is good at the work shop. now 2 time , I can not start. I am afraid to stop my car. I don’t know problem and very upset. some body know this problem pls tell me and help.
|
kothint
|
work shop master think computer electronic problem.
|
kothint
|
My Honda hybrid 2009 can’t start after engine stop. 3,4 hour wait and can start. I go to good work shop. work shop master do not know because my car is good at the work shop. now 2 time , I can not start. I am afraid to stop my car. I don’t know problem and very upset. work shop master think computer electronic problem.
some body know this problem pls tell me and help.
|
thanlhayt
|
Its must be ECU problem, I thing heat sensor false. U should try to test OBD2.
|
kothint
|
Can you explain more? Ko thanlhayt
engine heat is normal. no water boil. It happened 2 time and first I don’t know what to do, other people give help but can’t. a little long I can start.
I already clean fuel tank at work shop. they said everything ok. But, it happen again as same and wait 1 hour and ok. I want to know problem. I want to repair that problem. now it big problem for me.
where is good work shop and electronic repair shop for my car?
|
kothint
|
pls share honda hybrid car work shop and electric repair shop.
thanks.
|
Agera
|
If it’s because of ECU, u can diagnose it with digitally. It can be done at high performance service center for automobile like Auto Care service, BBLS auto service. Auto care is located on Pyay road near Junction Square and BBLS is at Bo Ta Htaung ts. U can check that centers on Face book with that names.
|
thanlhayt
|
Yeah, U better go there and check u car by OBD2.
|
mgzombe
|
ECU ဆုိတာ Engine Control Unit ကုိေခၚတာပါခဗ်ာ။ သူက အင္ဂ်င္ကုိ အီလက္ထေရာႏွစ္ ျဖစ္ ထိန္းခ်ဳပ္ၿပီးခုိင္းေစတဲ့ ယူနစ္တခုပါ။ သူက engine ရဲ႕ valve timing , fuel/air ratio , ignition timing ( စက္စတင္ႏႈိး ျခင္း ) ႏွင့္ Idel Speed ကုိ control လုပ္ေပးတယ္လုိ အၾကမ္းအားျဖစ္ နားလည္ႏူိင္ပါတယ္။ ေနာက္ပုိင္း ေမာ္ဒယ္ျမင့္ ကားေတြမွာေတြ႕ရတတ္တဲ့ Cruise Control ဆုိတာ ECU ကုိအသံုးျပဳၿပီး control လုပ္တာပါပဲ။
OBD II ဆုိတာကေတာ့ OBD 1 , 1.5 ေနာက္ပုိင္း အဆင့္ျမႇင့္ထားတဲ့ system တခုပါ ။ On-Board Diagnostics System လုိေခၚပါတယ္။
ကားရဲ႕ စက္ေခါင္းခန္း အဖံုး (Hood)ျမန္မာလုိ ေဘာ္နပ္  ထဲမွာ OBD device နဲ႔ ခ်ိပ္ဆက္ဖုိ႔ အတြက္ connector တခုပါပါတယ္။ အဖံုးတခုနဲ႔ ဖံုး ထားတတ္ပါတယ္ ။ အဲဒီ connector ကုိ data link connector လုိ႔ ေခၚတဲ့ cable နဲ႔ OBD ကုိ ဆက္သြယ္ၿပီး ECU မွာ ဘယ္လုိ error ေတြရွိေနလဲဆုိတာကုိ စစ္ေဆးရပါတယ္ ။ အဲဒီအခါမွာ သူက error ကုိ သူရဲ႕သက္မွတ္ထားတဲ့ CODE ေတြနဲ႔ေဖာ္ျပပါတယ္ ။ ဥပမာ – p1167 (Heater System error )
အေပၚက error ဟာ Honda Civic Hybrid ကားေတြမွာ ေတြ႕ရတတ္တဲ့ error မ်ဳိးပါ ။ အကုိကားက ဘာအမ်ဳိးအစားလဲဆုိတာမသိရေတာ့ ေျပာရခက္ပါတယ္။ အေကာင္းဆံုးကေတာ့ အေပၚကအကုိေတြ အၾကံေပးသလုိ အဆင္ေျပမယ့္ Workshop တခုခုမွာ စစ္လုိက္တာေကာင္းပါတယ္။
ဆရာဝင္လုပ္တယ္လုိမထင္ေစျခင္ပါဘူးခဗ်ာ ။ သိသေလာက္ဝင္ေျပာၾကည္တာပါ ။
|
aungphyohlaing
|
I suggest you to check your car pump… when it happen, is your pump is too hot?
|
kothint
|
Thank you all for good advice
I should go and check ECU now or wait for can’t start again and check?
I think engine not too hot when engine not start, Ko aungphyohlaing.
|
mgzombe
|
I alrdy told u need to be check at workshop. That’s not engine over heat.May be Ignition System Sensor error caused by over heat at that circuit . U cant know over heat at that by TOUCH , SENSE . They are interior parts of engine. Dun make a problem solve with pin to axe . 
|
kothint
|
Agera
BBLS is name of workshop. can you tell me complete name?
and location pls. thanks.
|
Agera
|
BBLS is at No.195, Bo Ta Htaung Zay street, yangon. Ph – 295495. No, u can find it with that name on facebook if u check it’s about.
|
kothint
|
Thank you Agera.
Actually I afraid to go workshop not quality and destory other good thing in the car and ask a lot money.
|
